Side-by-Side Top-Bottom
Actual Image

casuaris casuaris (80)
vanderschelden Gold Star Critiquer/Gold Star Workshop Editor/Gold Note Writer [C: 2553 W: 74 N: 7464] (30441)
Cassowaries (genus Casuarius) are very large flightless birds native to the tropical forests of New Guinea and northeastern Australia. Some nearby islands also have small cassowary populations, but it is not known if these are natural or the result of the New Guinea trade in young birds. They are frugivorous; fallen fruit and fruit on low branches is the mainstay of their diet. They also eat fungi, snails, insects, frogs, snakes and other small animals. Recently, they have also been spotted to attack humans, though this usually only occurs in self-defense when humans intrude upon the birds' territory or cause them to feel threatened.

Cassowaries (from the Indonesian name kasuari) are part of the ratite group, which also includes the emu, rhea, ostrich, moa, and kiwi. There are three species:
Southern Cassowary or double-wattled cassowary C. casuarius of Australia and New Guinea.
Dwarf Cassowary C. bennetti of New Guinea and New Britain.
Northern Cassowary C. unappendiculatus of New Guinea.

Altered Image #1

vanderschelden Gold Star Critiquer/Gold Star Workshop Editor/Gold Note Writer [C: 2553 W: 74 N: 7464] (30441)
Noise reduction with NeatImage
Edited by:AdrianW Gold Star Critiquer/Gold Star Workshop Editor/Gold Note Writer [C: 257 W: 185 N: 215] (710)

Load the pic into NeatImage, then click on the DeviceNoiseProfile tab. Since the image was captured in RGB, I'd switch the WorkingColorSpace to RGB.

Find an area without any important detail - the background to the right of his head is good - now select it by dragging a box. You'll get a warning about the RGB values not being uniform, ignore that - for the best noise profile you want an area without any detail at all, just noise - but there aren't any areas like that in the image.

Now go to the NoiseFilterSettings tab and draw a big box to see the effect of our current filter settings. Not pretty was it? That's due to the non-uniform profile area. It's fixable though! Look at the image again, you'll see that the noise is fine or medium - there aren't many large blotches, so under NoiseReductionAmounts set the Low slider to 0%. Looks a bit better doesn't it? Now play with each of the sliders in turn - try them at 0, wait for it to redraw, then try at 100. Now you know what the slider does - try finding the optimal value for it :)

Load back into Photoshop on top of the original image - turn the Layer on and off to see what effect we've had. In this case the results were mostly positive, except for a bit of detail lost around the edges - so use a soft-edged eraser to knock that out.

Finally SmartSharpen 75%, 0.8px, 0 to bring out the fine detail :)